Purchase this item to allow you to enable the Woolich Racing Launch Control. ** The Pit Speed Limiter and Engine Warm Up, requires the purchase of an additional Pit Speed Limiter Harness.Ģ017-2020 Kawasaki ZX10RR Launch Control Key ** This harness uses the stock exhaust valve plugs on the bike's harness, the stock exhaust valve should be removed from the bike and disabled in the WRT software This item is for the Race Tools Key Only, it allows you to enable Woolich Racing Race Tools using the stock Shift Sensor.
#Zx10r ecu flash install#
If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply). You can purchase this as a package on the product page for your bike. You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU. Woolich Racing Race Tools requires you to Write the ECU. ** The Pit Speed Limiter and Engine Warm Up requires the purchase of an additional Pit Speed Limiter Harness.
* Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length. Launch Control allows you to configure Delay, Launch RPM and Hold Speed.Įngine Warm up parameters are fully configurable. Pit Speed Limiter RPM can be configured.**
#Zx10r ecu flash full#
Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations.Īutoblipper Opening and Target maps are fully configurable per gear.
0 kommentar(er)
